![]() Good news is I can still open and display photo's etc from the folder structure, so it must be readable, just not sure how much of the data is still accessable/valid. Is this possible or can I attempt repair without risk of being worse off afterwards ? My fear is if I run a system repair that I will loose data, that at this stage can still be recovered, and might not be if I attempt a repair or even replace disk 1.ĭisk 2 and 4 are in good working condition, but since I have fault protection for only one drive and disk 1 has crashed and disk 3 is not recognised and/or well configured, my fear is to loose data. It copies the folder structure but not the contents. You can't create a new storage pool without losing all the data on the volume because that volume is not longer reliable or usable. The technical support of synology says to run a repair, but then again, backup or copy of data prior attempting such repair is advised. But I cannot run backup as the backup software is corrupt (probably due to bad sectors on disk) and I cannot seem to copy it. If the pool has crashed, it's because: the drive hardware has experienced a failure, or the filesystem has experienced a failure, or both of the above. Checking filesystem on /dev/md2 UUID: 7a29febb-e9b5-4f77-afd7. btrfsck /dev/md2 Syno caseless feature on. In order to stop I/O to the volume (although it was already in RO mode per the output of dmesg above. I have 4 drives of 4TB, drive 1 has crashed and drive 3 has status 'initialised' but 'not assigned to storage pool'. It's a Synology Hybride Raid (SHR) with data protection for 1-drive fault tolerance. This stops the WebUI etc., but keeps SSH on. ![]() ![]() 'Failed to access the system partition.' This happened after a physical drop/tumble. I have a DS415play which storage pool has crashed. How to Repair Synology Volume when receiving critical errorIn this video I walk through the process of repairing a degraded volume with a drive that is repor. I would like to get in touch with someone who has some experience in solving a technical issue regarding my Synology NAS. The memory then swap began filling up to 99 before eventually crashing the entire system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |